Dirty hand 100481 Manuale operativo - Pagina 13

Sfoglia online o scarica il pdf Manuale operativo per Spaccalegna Dirty hand 100481. Dirty hand 100481 16. 5-ton electric log splitter

Operating Instructions

Always wear safety glasses, safety shoes, and suitable work

clothes when operating the log splitter. Do not wear neckties,

scarfs or other loose clothing that could get caught in moving

parts.

Keep hands and feet clear of the ram and wedge at all times.

Keep away from flammable liquids and gases before starting.

1) Place the log splitter on a sturdy, level surface. Block the wheels

to prevent movement of the log splitter during operation.

2) Make sure the handle is free of oil, grease and resins.

3) Oil the wedge and the top of the beam for smoother operation.

4) Ensure the equipment is in safe working condition. Operate the

unit without loading to make sure it is working normally. Check

all nuts, bolts and hydraulic fittings are tight. Check the switch,

power cable and plug for damage to avoid electric shock. Check

that all safety shields are in proper position.

5) Check that the outlet's main voltage and frequency match the

data stated on the model plate.

6) Plug in the power cable and switch on the motor. NEVER use

an extension cord longer than 25 feet. Minimum cord gauge

must be 16. The power supply for this log splitter must have a

protection device (circuit breaker) for over or under voltage.

7) Place a log on the beam against the push plate. Make sure that

the log is securely on the beam and up against the push plate.

Logs should be cut with square ends and to a maximum length

of 20 in. in advance. Always use extra care when splitting logs

with unsquare ends.

8) Two controls must be activated to operate the log splitter. The

hydraulic control lever and the ON/OFF push button must be

held during the splitting process. If either control is released, the

log splitter will stop operating.

9) Loosen the bleed screw one or two turns if necessary.

10) Depress and hold the ON/OFF push button with your right

hand and allow the motor to cycle up to speed.

11) Push down on the hydraulic control lever.

12) Release the ON/OFF button and the control lever when the log

is split. The push rod will then retract.

WARNING