Cub Cadet Z-Force S Manuale dell'operatore - Pagina 5
Sfoglia online o scarica il pdf Manuale dell'operatore per Tagliaerba Cub Cadet Z-Force S. Cub Cadet Z-Force S 20. 58” snow blade
Anche per Cub Cadet Z-Force S: Garanzia limitata (1 pagine)
Stampa la pagina
WARNING!
Disengage the PTO, engage the brake
lock, and stop the tractor engine before performing any
preparation procedures. Place the tractor on a firm and
level surface before beginning installation procedures.
WARNING!
The exhaust system and surrounding
areas are HOT. To avoid personal injury, allow the
tractor to cool before beginning any blade
installation procedures.
NOTE: The hardware used to install some components on the
snow blade has been loosely installed for shipping purposes. To
assemble the blade it may be necessary to remove this hardware
to complete installation.
NOTE: Do not remove the deck or other attachment from the
tractor until instructed below.
Blade Installation
1.
Place the deck lift handle in the lowest position.
2.
Remove the deck hanger rod by removing the two lock
nuts in the front of the pivot pins and the jam lock nuts (if
equipped) on the back of the pivot pins. See Figure 2-1.
Figure 2-1
3.
When the deck hanger rod has been removed, the pivot
pins will also need to be removed from the deck hanger
brackets. See Figure 2-2.
Figure 2-2
4.
Carefully remove the cotter pins in the pivot pins. See
Figure 2-2.
5.
When the pivot pins are removed, save the four flat
washers (two on each pivot pin) for re-installation of the
new pivot pins.
6.
With the deck lift still in the lowest position, remove the
deck as instructed in the tractor operator's manual.
7.
On Z-Force S tractors remove the pedals and the park
brake/cruise control lever. See Figure 2-3.
Figure 2-3
S
ection
2 — A
& S
-U
SSembly
et
p
5