Acorn Safety S0440-FRV Istruzioni per l'installazione, il funzionamento e la manutenzione - Pagina 4

Sfoglia online o scarica il pdf Istruzioni per l'installazione, il funzionamento e la manutenzione per Prodotto idraulico Acorn Safety S0440-FRV. Acorn Safety S0440-FRV 5. Freeze resistant wall mounted emergency eye/facewash

Stampa la pagina

Installation & Operation Manual

OPERATION INSTRUCTIONS:

Employees who work with hazardous materials should

become familiar with the location and operation of the

nearest emergency plumbing fixture. Emergency plumbing

fixtures stations are simple to use and require hands free

operation once the station is activated. Regular instruction

regarding proper care and use will increase confidence

that the units are accessible and function properly.

The route and area surrounding the Eye/Face Wash

should be clear and unobstructed; the sooner eyes are

flushed, the less likelihood of damage. Eye/Face Wash

stations should be located in close proximity to the hazard

and take no more than 10 seconds to reach. In the case of

sever eye contamination the victim may require assistance

to the Eye/Face station and help flushing their eyes.

Safety plumbing fixture equipment should be operated

weekly for a period long enough to verify operation, clear

the supply line of any sediment build-up and minimize

microbial contamination due to sitting water.

1. To start the Eye/Face, push activation paddle from the

horizontal to vertical fully "ON" position. Flushing should

start, popping the spray nozzle caps open.

2. Lower both eyes into flow. Both eyes should be flushed

to prevent contamination from one eye from being

delivered to unaffected eye. Personnel who wear

contact lenses should remove them immediately prior to

or during the flush to prevent the contamination from

remaining against the cornea possibly causing

unnecessary damage or pain.

3. Using thumb and forefingers, fully open eyelids and

flush eyes thoroughly for approximately 15 minutes or

until medical personnel arrive. Be prepared to let the

doctor know what type of contamination has entered the

eye.

4. When finished return the push paddle to the horizontal

or fully "OFF" position. Flushing fluid should stop. Once

flushing fluid has stopped flowing, return spray nozzle

lids to the closed position to protect from airborne

contaminates.

MAINTENANCE GUIDE:

Maintain and inspect in accordance with ANSI Z358.1

1. Check for obvious signs of wear, broken or defective

equipment. Re-paint if necessary. Replace missing or

defective equipment such as broken push paddles,

missing signs and inspection tags.

2. Remove strainer and washout any debris collected

–replace as required.

3. Operate Eye/Face Wash nozzles using the push paddle

to place ball valve in the fully "ON" position checking for

smooth operation of valve push paddle mechanism at

the same time ensuring that the Eye/Face spray nozzle

caps pop off immediately when actuated. If the ball

valve does not operate smoothly check the actuating

assembly for binding or missing parts. If the Eye/Face

spray nozzle caps do not pop off immediately when

actuated check for correct supply inlet pressure.

Acorn Safety

a division of Acorn Engineering Company™

Manual #7109-516-001

4. While in operation, inspect spray nozzles for clogs or

debris correct or replace as required.

5. Return push paddle to vertical or fully "OFF" position

and swing back to stand by position. To prevent

Eye/Face Wash spray nozzles from becoming

contaminated, always close nozzle lids after each

use.

Page 4 of 5

Revised: 06/01/2022