Disaster Area Designs Qconnect Manuale d'uso - Pagina 11

Sfoglia online o scarica il pdf Manuale d'uso per Apparecchiature di registrazione Disaster Area Designs Qconnect. Disaster Area Designs Qconnect 16. Multi output midi controller

Stampa la pagina

mpress

To configure your Empress Reverb or Echosystem pedal with qCONNECT, plug in a TRS / mono

cable from one of the ports on qCONNECT to the Control Port on the back of the Empress pedal.

Enter Setup on the qCONNECT and configure the port you're using as TIP or MID.T.

Set your desired device mode to EECO (Echosystem) or EMPR (Reverb.) Remember to hold the

right footswitch to save.

Example: If you want to use an Empress Reverb as your sixth MIDI device connected to Port Y, you

would set DevF = EMPR, CFG.Y = MID.T in the qCONNECT Setup menu.

Enter the Advanced Configuration mode on the Empress pedal by holding the Select and

Bypass footswitches, then pressing the Save button. The preset LEDs on the Empress pedal will

blink yellow twice to indicate that you are in Advanced Configuration Mode.

Rotate the mode selector knob until the second mode LED lights (plate or tape) then turn the

upper left knob (decay or delay time) until the fifth preset LED lights blue.

P 01

Then rotate the mode selector knob to the seventh mode LED lights (ambient swell or ambient,)

and then turn the upper left knob to select the MIDI channel. The preset LEDs will light to show

the MIDI channel from 1 to 16. Example: To set the Reverb to MIDI channel 6, turn the decay knob

until the first preset LED lights green.

Hold the Select and Bypass footswitches to save and exit Advanced Configuration mode.

Your Empress pedal is now configured!

edal

etup

P 01

uide

HOLD

PRESS

HOLD