Disaster Area Designs Qconnect Manuale d'uso - Pagina 7
Sfoglia online o scarica il pdf Manuale d'uso per Apparecchiature di registrazione Disaster Area Designs Qconnect. Disaster Area Designs Qconnect 16. Multi output midi controller
Stampa la paginamidi
tip
on
By now you know that some of your devices need to receive MIDI on the ring of their jacks,
and some on the tip. But one of the setup options is BOTH, so what's up with that?
Well, this goes back to the setup for Ports X and Y. If you want to use one or both of them for
expression or tap, that means you can't connect MIDI device to them. You're left with only
ports A-F, for six devices, and that's no good.
We decided to put in the capability to run both the ring and tip simultaneously from any
output, which then lets you use an inexpensive TRS Y cable (sometimes called an insert cable)
to split out to two devices. In this way, you can use two Y cables in any of the normal ports to
bring you back up to eight total!
Plug the center stereo end of the Y cable into the port you wish to use, then set up the port
configuration to BOTH or MID.B in the Setup menu. That's all you need to do.
Please note that if you want to use Y cables to connect to Chase Bliss devices then you'll need
to use our MJ-Y-RP2 cables to make the ring of the cables active.
s
etting up Your
Now that everything is connected and the qCONNECT is configured, you will need to go to
each of your MIDI devices and make sure that each one is set up to receive MIDI on the correct
MIDI channel.
Every device is a little different, and we can't cover the more than 100 different devices that
qCONNECT can control in depth. But we have created guides that show how to configure the
most common MIDI devices you might like to use, and you'll find them on the next few pages.
For devices we haven't covered, the general procedure is as follows:
Go into your device's setup menu or utility and ensure that its MIDI input is activated or
enabled.
Configure the device to receive MIDI on the correct channel.
qCONNECT
Device
devA
devB
devC
devD
devE
Note: There is no device "I" since that looks an awful lot like "1" on the display!
That's pretty much it. If you've told qCONNECT what kind of pedal or device you have on the
correct channel, its important commands will be automatically configured and you should be
ready to go!
Please read through the next few pages for setup info on the most popular 1/4" MIDI devices.
ring
and
d
eviCes
MIDI
Channel
1
2
3
4
5
qCONNECT
Device
devF
devG
devH
devJ
MIDI
Channel
6
7
8
9
5