Disc Makers Elite2 Manuale introduttivo - Pagina 3

Sfoglia online o scarica il pdf Manuale introduttivo per Hardware del computer Disc Makers Elite2. Disc Makers Elite2 15. Elite series

Elite2_Getting_Started_04.indd 3

Note: USB 1.0 interfaces cannot handle the data transfer rates required for disc

duplication tasks. If your system has USB 1.0 ports, you must upgrade to USB 2.0 to

use the duplicator. Add-on boards can be purchased and installed to perform this

upgrade.

Connecting the power and printer cables

Note: After connecting the power cables, as described in the following steps, do

not power up the system until you have completed the procedure in the next sec-

tion, titled Preparing the printer.

At the back of the duplicator cabinet, connect the AC power cord to the unit.

Connect the other end to a UPS device, AC power strip, or AC wall outlet.

Connect the AC power adapter for the printer to the AC power cord. Plug one

end into the printer DC input connector and the other end into a UPS device,

AC power strip, or AC wall outlet.

Printer USB

Printer DC Input

AC Power Connector

Duplicator Power

Ensure that the cable that emerges from the middle of the duplicator cabinet

and connects to the Printer Control port is securely attached.

Connect the USB cable from the USB to Printer connector on the back of the

cabinet to the USB connector on the back of the printer enclosure (directly

above the printer power input).

Preparing the printer

The self-contained printer included with the Elite 2 duplicator features its own

power supply and individual controls. Before using the printer or the duplicator,

install the two print cartridges provided as described in the following sections.

Elite 2 Getting Started Guide

Printer Control

USB to Disc Drives

USB to PC

2/20/06 4:07:24 PM