Disc Makers Forte Manuale di avvio rapido
Sfoglia online o scarica il pdf Manuale di avvio rapido per Hardware del computer Disc Makers Forte. Disc Makers Forte 2. Disc makers forte disc duplicators: quick start
Stampa la paginaDISC MAKERS
DUPLICATING
WITH YOUR FORTE:
The Forte duplicates in two di erent modes, Single Master
and Multi Master. The single master mode allows you to
make many copies of a commonly used master disc stored
on the hard drive. The multi master allows you to produce
multiple copies of more than one master disc.
NOTE: Before either process you MUST
make sure the DISC BIN is FULLY EXTENDED
with the SWING GATE tilted TOWARD the UNIT.
YES!
SWITCHING BETWEEN SINGLE
MASTER AND MULTI MASTER:
Power on the Forte by ipping the black power switch
1
located on the back of the unit. When initialization is
complete, this image will appear on the LCD screen:
DISCMAKERS
1. Copy
From the main "1. Copy" screen press the Master hot
2
key directly below the display.
Your screen will read master mode multi master like
3
the following image:
t
FORTE
MASTER MODE
MULTI MASTER
Use the up and down arrows to rotate through
4
single master and multi master mode. Then
press "ENT" button to con rm your selection.
Press the up arrow until you return to the
5
"1. Copy" Display.
MAKING COPIES IN
MULTI MASTER MODE:
NO!
Con rm the lower right of the display reads MM for
1
Multi Master. If not refer to the switching to master
mode section in the previous section.
Place the number of blanks you need copied into the
2
inner bin, below the robotic arm (you can stack multiple
sets of blanks and master discs). Press enter on the "1.
Copy" screen. The Forte will pick up the top master disc
and load that information to the hard drive. Once
completed it will drop the master on the output spindle
and begin duplicating your blanks.
When the Forte detects a new master disc it will begin
3
copying it until it dectects another master or the bin is
empty.
(SM)
MAKING COPIES IN
SINGLE MASTER MODE:
Con rm the lower right of the display reads SM to
1
stand for Single Master. If not refer to switching to
master mode section in the previous section.
www.discmakers.com
To load the master to the internal hard drive press the
2
LOAD hot key found underneath the LCD display. Press
the ENT button and the following will appear on the LCD
screen:
HARD DRIVE SETUP
1. SELECT PARTITION
Place your master in the inner bin, below the robotic
3
arm. Press the DOWN arrow until it reads "2. Load New
Partition" and press the ENT key. You will be prompted to
enter a name for the master so it can be retrieved for
future duplicates. Using the arrows buttons scroll
through the alphanumeric characters and press ENT to
select. The master disc will load to the hard drive; when
completed the LCD screen will read Load Partition OK.
Press the ESC button and Up or Down arrows until you
4
are on the "1. Copy" screen and place the amount of
blanks you need copied in the inner bin.
From the "1. Copy" screen press the ENT button and your
5
recently loaded master will appear on the screen. Press
the ENT button twice to start the burning process
(NOTE: to use counter feature see instructions on back).
Once the burn is done you will be able to retrieve your
copies from the front bin of your Forte.
TURN TO THE BACK FOR
FURTHER INSTRUCTIONS
1-888-800-4038