Disc Makers Reflex7 Manuale di istruzioni - Pagina 7

Sfoglia online o scarica il pdf Manuale di istruzioni per Hardware del computer Disc Makers Reflex7. Disc Makers Reflex7 13. Dvd/cd-r
Anche per Disc Makers Reflex7: Manuale di avvio rapido (2 pagine)

Stampa la pagina

1. Installation and Setup

Copy and Compare

The COPY AND COMPARE function will perform duplication and then compare the

duplicated discs with the master disc or hard drive disc image. With this function, the

discs that have been duplicated properly will be ejected and re-inserted again in the writ-

ers automatically for comparison to the original disc or hard drive disc image. The good

discs will be ejected automatically after comparison. The failed CD discs will remain in

the writers. Pressing the STATUS button will eject those failed discs.

Only data CDs can be compared with the master disc. Audio or video CDs will be VERI-

FIED (self-reading) instead of being compared with the master even if COPY AND COM-

PARE is selected.

Emulate

The EMULATE function performs the same operation as COPY except that the

data is not actually written onto the CD-R media. CD-R discs will remain blank when the

emulation operation is performed. This operation is used to confirm the status of the tar-

get master disc, or the hard drive disc image. It is also used to test the system during

setup or after being transported.

Compare

The COMPARE function performs comparison between master and target discs (data

CDs only).

Verify

The VERIFY function performs verification of audio or video data written to blank

CD-R media from a target or master disc. Different discs in the CD writer and CD

reader can be verified together simultaneously.

Load

Use the LOAD function to load master data into the hard drive before performing

other functions.

Place the master CD disc into the top reader drive or any one of the CD writers,

ReflexPro will automatically detect and analyze the master CD and load its data into the

current partition of the hard drive.

The hard drive installed in the ReflexPro will be automatically partitioned by

900MB in each partition. Number of partitions available depends on the hard drive's

capacity. No pre-formatting or software setup is required to install the hard drive. Each

partition in the hard drive will be labeled in alphabetical order. Partition numbers can be

selected under HDD PARTITION in the Setup menu.

The ReflexPro will prompt you with an error message when you try to duplicate from a

partition that contains no data. Switch to a proper partition or use the LOAD function to

load the master data into the current partition.

www.discmakers.com

1-888-800-4041