Cub Cadet 190-341-100 Manuale dell'operatore - Pagina 12
Sfoglia online o scarica il pdf Manuale dell'operatore per Spazzaneve Cub Cadet 190-341-100. Cub Cadet 190-341-100 20. 42" snow thrower attachment for cub cadet series 2000/2500 tractors
Anche per Cub Cadet 190-341-100: Manuale di istruzioni per l'installazione e la manutenzione (20 pagine)
Stampa la pagina
Installation & Removal
Snow Thrower Installation
WARNING!
assembly onto the tractor, ensure the PTO switch
and ignition switch are in the OFF position, the
parking brake is locked, and that the exhaust system
and surrounding areas have adequately cooled.
NOTE: To ease insertion into the tractor frame channels, apply
a light coating of grease to the channel brackets of the snow
thrower hitch assembly ( Refer to Figure 5-3).
1.
Position the snow thrower assembly directly in front of the
tractor with the subframe assembly extending rearward.
NOTE: Because of lower ground clearance on tractors
equipped with 15" front tires and 20" rear tires, the gearbox
mounting bracket, as assembled on the snow thrower
subframe, may not clear the front axle of the tractor. Note
that steps 2, 3 and 6 apply only to these tractors.
2.
Units with 15" front tires ONLY. Remove the front hex flange
lock nuts and cap screws securing the gearbox mounting
bracket to the subframe arms. Loosen the rear fasteners.
See Figure 5-1.
LOOSEN
REAR
FASTENERS
GEARBOX
MOUNTING
BRACKET
3.
Units with 15" front tires ONLY. Using care to avoid
separating the rear half of the drive shaft from the front
half, tilt the gearbox mounting bracket rearward. See
Figure 5-2.
NOTE: Turning the tractor's front tires fully to the left or
right will slightly raise the front axle of the tractor and
provide more ground clearance.
12
Before installing the snow thrower
REMOVE
FRONT
FASTENERS
SUBFRAME
ARM
Figure 5-1
DRIVE SHAFT
HALVES
Figure 5-2
4.
Slide the snow thrower assembly rearward until the
channel brackets of the hitch assembly engage the frame
channels of the tractor. See Figure 5-3.
FRAME
CHANNEL
LIFT HANDLE
Figure 5-3
5
GEARBOX MTG.
BRACKET TILTED
REARWARD
CHANNEL
BRACKETS
FRONT LIFT
SHAFT