Blade Vusion 250 V2 Manuale di istruzioni - Pagina 5

Sfoglia online o scarica il pdf Manuale di istruzioni per Droni Blade Vusion 250 V2. Blade Vusion 250 V2 18. Fpv-ready racing drone rtf

Installing the Transmitter Batteries

1. Remove the battery door screw.

2. Slide the battery door down to open.

3. Install 4 AA alkaline batteries in the transmitter.

4. Re-install the battery door and battery door screw.

Replace the transmitter batteries when the transmitter

indicates low voltage. The right LED ﬂ ashes and the

transmitter beeps when the battery voltage is low.

Install the video transmitter antenna in the top of the

quadcopter as shown.

NOTICE: Never install the ﬂ ight battery or power on

the quadcopter without the video transmitter antenna

installed. Doing so, even for a short time, will damage the

video transmitter.

1. Remove the battery compartment cover by pulling on the

edge of the cover to unsnap it from the frame.

2. Slide the ﬂ ight battery into the quadcopter frame and

re-install the cover.

3. Lower the throttle to the lowest position.

4. Power on the transmitter.

IMPORTANT: Always power the transmitter on before

powering on the aircraft.

5. Connect the battery cable to the aircraft power lead,

noting correct polarity. Do not move the quadcopter until

the receiver initializes.

CAUTION: Connecting the battery to the aircraft

power lead with reversed polarity will cause

damage to the power distribution board, ESCs and the

battery. Damage caused by incorrectly connecting the

battery is not covered under warranty.

6. The quadcopter motors will beep once and the receiver

status LED will glow solid red.

IMPORTANT: If the receiver status LED ﬂ ashes red, the

transmitter is not bound to the aircraft. See the Binding

section to re-bind the aircraft to the transmitter.

CAUTION: Always disconnect the Li-Po battery from the quadcopter when not ﬂ ying to avoid over-discharging the

battery. Batteries discharged to a voltage lower than the lowest approved voltage may become damaged, resulting

in loss of performance and potential ﬁ re when batteries are charged.