Acorn Safety S1360-HT Istruzioni per l'installazione, il funzionamento e la manutenzione - Pagina 5

Sfoglia online o scarica il pdf Istruzioni per l'installazione, il funzionamento e la manutenzione per Apparecchiature per il bagno Acorn Safety S1360-HT. Acorn Safety S1360-HT 11. Heat traced shower

Stampa la pagina

Installation & Operation Manual

INSTALLATION INSTRUCTIONS:

Supplies required: (not provided by Acorn)

1. Wall fasteners for signage mounting.

2. Floor fastener anchors, washers and bolts.

3. Pipe sealant or Teflon tape for sealing water connections.

IMPORTANT: FLUSH WATER SUPPLY LINES PRIOR TO

CONNECTION TO SAFETY EQUIPMENT.

NOTES:

—

Heat Trace cable used on this model is intended to

prevent freezing and will not provide tempered (heated)

water. It is recommended to supply this combination

shower assembly with a tempering system in compliance

with ANSI Z358.1.

—

Bottom of shower head must be between 82"-96" from

finished floor in order to meet ANSI Z358.1

—

Use hand tools and wrenches in a manner which will

prevent marring finished surfaces. Strap wrenches or

tools with plastic jaw linings are highly recommended.

—

Refer to Rough-in for location of supply and drain lines.

—

Fragments of Teflon tape or pipe sealant residue can

interfere with the proper operation of this unit. Ensure

pipe sealant methods do not cause contamination in the

system.

—

Prior to beginning assembly, TURN OFF water supply to

1 ¼" potable water supply line.

STEP ONE: PEDESTAL

1. Position center of pedestal assembly "A" a minimum of

1'-8" from all walls. While holding the assembly in

position, mark floor flange mounting hole positions.

2. Remove assembly and install appropriate floor anchors

to receive mounting bolts (supplied by others).

3. Re-position assembly and install mounting bolts and

washers.

STEP TWO: SUPPLY AND SANITARY DRAIN

CONNECTION

Note: Refer to Rough-In for supply line locations.

1. Install necessary pipe fittings (supplied by others) to

make connection to 1 ¼" NPT supply union w/ potable

water supply line. Either top or bottom supply may be

used.

2. Make sure proper drainage is supplied nearby.

3. Install supply union not used in FPV (Freeze Protection

Valve).

4. Tie the Heat Trace cable to the FPV with Cable ties or

Fiberglass tape. (See Detail)

5. Insulate FPV with foam insulation. (Supplied by Others)

6. Tubing can be connected to the outlet of the Freeze

Protection Valve if desired. Make sure the tubing is not

kinked & draining water will not freeze.

Acorn Safety

a division of Acorn Engineering Company™

Manual #7109-208-001

SUPPLIED HEAT

TRACE CABLE

MOUNTING SCREWS

& HARDWARE TYPICAL

2X (PROVIDED BY

INSTALLER)

INSPECTION TAG

LOCATION

MOUNTING BOLTS

& HARDWARE TYPICAL

4X (PROVIDED BY

INSTALLER)

Page 5 of 11

EXISTING SUPPLY

FPV DETAIL

LOCATED ON

Revised: 11/12/18