BLADEZ PB-SM 817 Manuale del prodotto - Pagina 15
Sfoglia online o scarica il pdf Manuale del prodotto per Scooter BLADEZ PB-SM 817. BLADEZ PB-SM 817 17. Electric power board
Stampa la paginaTROUBLESHOOTING GUIDE
The following guide will help assist you in identifying and correcting common problems with your XTR-SE:
Symptoms
The charger light indicates a full
charge right away.
Batteries do not hold a charge.
Unit does not have specified
travel range.
Unit moves intermittently, or very
slow.
Unit will not move when throttle
lever is activated.
Unit stops abruptly during use.
Bladez Corp. • 20155 Ellipse • Foothill Ranch, CA 92610 • (866) 325-2339 • www.ebladez.com
Potential Causes:
The batteries are fully charged.
New scooters come charged in
the box.
Batteries have reached the end
of their useful life or voltage
difference between batteries is
greater than .3 volt.
Batteries are dead.
Charger is malfunctioning.
Loose battery wire.
Batteries not fully charged or
voltage difference between
batteries is greater than .3 volt.
Throttle plug is loose at controller
board.
Throttle connector is unplugged
from the controller board.
Batteries are dead.
Defective throttle assembly.
Defective controller board.
Circuit breaker has "tripped".
Loose battery wire.
Page 14
Solutions:
No action needed. New scooters
should be charged for 6-8 hours
prior to first use.
Replace batteries.
Replace batteries.
Replace charger unit.
Lift the deck and check for a
loose battery connection.
Charge or replace batteries.
Lift the deck and verify that the
yellow throttle plug is pushed all
the way into the connector on the
controller board.
Lift the deck and plug the yellow
throttle connector into the yellow
connector on the controller
board.
Replace batteries, charger or
circuit board.
Replace throttle assembly.
Contact Bladez customer
service.
Allow electric motor to cool and
reset circuit breaker by turning
power switch off and on.
Lift the deck and check for a
loose battery connection.