Discount Equipment SS-18 Manuale dell'operatore - Pagina 7

Sfoglia online o scarica il pdf Manuale dell'operatore per Sega Discount Equipment SS-18. Discount Equipment SS-18 9.

Stampa la pagina
E-SS-16/18-IE-2198
COOLANT REQUIREMENTS
1.
You must use water when cutting with diamond blades or abrasive blades marked as "WET CUTI/NG BLADE". A
supply of 2 Y, to 5 gallons per minute (GPM) is necessary. Attach water hose to coolant
valve
or pump. Adjust
valves
to control the trow of water.
2.
For diamond blades or abrasive blades marked "DRY CUTIING BLADE", water may be used for controlling dust, but
is not required for cooling.
EDCO DOES NOT RECOMMEND THE USE OF ABRASIVE BLADES.
BLADE SELECTION
1.
Choose the proper blade for your job. Significant factors that determine blade selection include:
2.
What is the hardness and composition of slab.
3.
Are re-bars present?
4.
What is the depth of cut?
5.
What is the length of cut?
6.
Give your dealer complete information. Let him advise you on blade selection.
7.
Always use blades with a "Drive Pin Hole" to prevent blade from slipping.
LIFTING AND LOWERING OF BLADES:
1.
Reference Figure 1.
2.
Pull knob up on the Depth Control Hand Crank (1) to lift locking pin out of stop hole in saw console.
3.
Turn Depth Control Hand Crank in the direction UP/DOWN as indicated by arrows on crank assembly.
4.
Each complete turn of the crank will raise or lower blade approximately 3/16".
5.
Continue turning in the "UP" direction until blade is clear of slab surface before starting engine.
BEFORE ATTEMPTING TO CUT ... READ AND UNDERSTAND "SELECTING
DEPTH OF CUT" INSTRUCTIONS BELOW.
SELECTING DEPTH OF CUT
1.
Depth of cut is selected by turning Depth Control Hand Crank. (1)
2.
Position saw over cutting line.
3.
Blade should be raised and engine at full throttle.
4.
If cutting WET: Be sure water is flowing freely to the blade.
5.
Pull knob up on the Depth Control Hand Crank (1) to lift locking pin out of stop hole in saw console.
6.
Slowly turn hand crank in DOWN direction.
7.
Continue turning until blade has penetrated slab to desired depth.
MAXIMUM DEPTH OF CUT:
8.
Each complete turn of the cra.nk will lower blade approximately 3/16".
for t4" diameter blade .......... 4
Y."
9.
Never
cut deeper than is necessary.
for 16" diameter blade .......... 5
Y."
for 18" diameter blade .......... 6
Y."
The depth of cut can be controlled two different ways:
1.
Mark blade prior to starting cut.
b.
Use heavy permanent marking pen.
c.
Measure back from the blade edge the dapth you wish to cut.
d.
Mark blade with heavy line. This line will be visible as blade is turning.
e.
When mark reaches slab surface, cutting depth has been reached.
2.
Lower blade until approximate depth has been reached.
a.
Raise blade, counting the number of turns on the Depth Control Hand Crank and stop saw.
b.
Move the saw away from the cut and measure depth with ruler.
c.
Adjust depth accordingly.
Once desired depth is reached, drop lock pin into hole in console. Blade will be locked at this selected depth.
6