DISCOVER LYNK Edge Card Victron Manuale d'uso - Pagina 4

Sfoglia online o scarica il pdf Manuale d'uso per Camera Accessories DISCOVER LYNK Edge Card Victron. DISCOVER LYNK Edge Card Victron 9. Lithium ion battery

Stampa la pagina

3. Overview

3.1 System Overview

The AES LYNK Communication Gateway unlocks the full potential of a Discover AES LiFePO
internal Battery Management System (BMS) to optimize the charge and discharge configurations of the world's best inverter
chargers and solar charge controller systems in a closed loop configuration.
AES LiFePO
batteries must be set up to work with Power Conversion and Monitoring devices in either an Open Loop or
4
Closed Loop configuration. AES LiFePO
manually through the controller for the Power Conversion device at the time of installation. This is commonly refered to as
a 'lead acid drop-in replacement' configuration. In a Closed Loop configuration the battery charge and discharge rates and
settings are dynamically controlled by the BMS of the AES LiFePO
devices in the network.
To connect with the communication network of a specific brand of inverter charger or solar charge controller, the LYNK
Communication Gateway requires an AES LYNK Edge Card with the appropriate communication port.

3.2 Minimum Battery Capacity

Battery charge and discharge rates are managed automatically by the AES
very large solar arrays with battery banks that are too small can exceed the operating limits of the battery to charge and
possibly lead to the BMS triggering over-current protection. Battery capacity must be sized to accept the maximum charge
current of the system, or the the charging devices must be curtailed to charge below the operating limit of the installed
batteries. This value is derived by adding together the charge capacities of all inverter/chargers and solar charge controllers
in the system. Additionally, battery peak capacity must be sized to support the surge requirements demanded by the load
attached to the inverter. Match the sum of all inverter peak power values with the sum of all battery peak battery current
values.
Model
MultiPlus 48/3000/35
MultiPlus / Quattro 48/5000/70
Quattro 48/8000/110
Quattro 48/10000/140
Quattro 48/15000/200
MultiPlus / Quattro 24/3000/70
MultiPlus / Quattro 24/5000/120
MultiPlus / Quattro 24/8000/200
4
battery charge and discharge settings in a Open Loop configuration are set up
4
Inverter Peak
(92% Efficiency at 48V)
136 Adc
226 Adc
362 Adc
452 Adc
566 Adc
Inverter Peak
Model
(92% Efficiency at 24V)
271 Adc
452 Adc
724 Adc
4
Battery over a connection with the power conversion
4
LiFePO
Battery and Victron CCGX device.
4
Single Phase
Charger
Minimum
42-48-6650
35 Adc
1
70 Adc
1
110 Adc
2
140 Adc
2
200 Adc
2
Single Phase
Charger
Minimum
44-24-2800
70 Adc
120 Adc
200 Adc
Battery by enabling the
Using
Three Phase
Minimum
42-48-6650
2
3
4
5
6
1
2
3
discoverbattery.com