Cubert S185 Manuale d'uso dell'hardware - Pagina 10
Sfoglia online o scarica il pdf Manuale d'uso dell'hardware per Fotocamera digitale Cubert S185. Cubert S185 17.
Stampa la pagina4 Camera preparation and
operation basics
Prior to any camera use, you should check for any apparent damages. Furthermore, you should perform a
functional test.
The next section outlines the first steps for the operation of the camera. Please read this section carefully
and follow the instructions.
4.1 Power supply
Power can be supplied either by the power adaptor or by battery. Please only use the recommended
components. If you used any other power supply, do meet the voltage and current requirements.
Furthermore, you should take safety measures against over-voltage. A 2.1x5.5x9.5 Pin power jack is used.
Please see chapter 7 (technical data sheet, camera).
4.1.1 Mains operation
The S185 can be operated with the shipped power
adaptor. Plug the Y power cable into the camera and
the PC and connect it with the power adaptor. As soon
as the camera and the Cubert Mini-PC server are on
power, they will switch to operating mode and – with
a short delay of max. 2 minutes – can be used.
4.2 Data connection
Cubert's Hyper-Spectral camera can be operated in different modes. The different operation schemes are
summarized in the software and installation guide (chapter 2). In principle, the S185 can be operated with the
following two operation schemes:
4.2.1 Direct connection
For operation, directly connect your PC's NICs to the
camera via Gigabit Ethernet patch cables (RJ45 jacks,
CAT5 or better). Your client PC will be used as Cubert
server and Cubert client. Please refer to chapter 2,
operation scheme 1 in the software and installation
guide.
www.cubert-gmbh.de
Upon damage or malfunction please contact Cubert support.
4.1.2 Battery operation
The S185 can also be operated on battery. For this
purpose, plug the Y power cable into the camera and
the PC and connect it with the battery. As soon as the
camera and the Cubert Mini-PC server are on power,
they will switch to operating mode and – with a short
delay of max. 2 minutes – can be used. Pay attention
to a sufficient battery charge level in order to avoid
outage during measurement.
4.2.2 Remote controlled (recommended)
For remote-controlled operation connect your camera
to the Cubert Mini-PC server with 2 Gigabit Ethernet
patch cables (RJ45 jacks, CAT5 or better). It is crucial,
that you connect the correct respective network ports
(chapter 5, operation scheme). The Cubert Mini-PC
server will automatically establish the connection to the
camera and run the server process C-link upon
power-up. It can be accessed by any other PC with
installed client software (recommended: Cube-Pilot) via
WiFi. Please refer to chapter 2, operation scheme 4 in
the software and installation guide.
6