Dish Network Tailgater Manuale d'uso - Pagina 6
Sfoglia online o scarica il pdf Manuale d'uso per Antenna Dish Network Tailgater. Dish Network Tailgater 18. Portable antenna
Anche per Dish Network Tailgater: Manuale (2 pagine)
Stampa la pagina
- 1. Table of Contents
- 2. Introduction
- 3. Important Safety Instructions
- 4. Tailgater Package Contents
- 5. About Satellite TV Reception
- 6. About Signal Loss
- 7. Connect Receiver to TV
- 8. Tailgater Operation
- 9. Security
- 10. Proper Care of Your Equipment
- 11. Troubleshooting
- 12. Troubleshooting
- 13. Manufacturer's Limited Warranty
- 14. FCC Guidelines
The Tailgater requires an unobstructed view of the southern sky for signal reception. Be sure to
place the Tailgater in a location free from obstructions such as trees, buildings, etc. (See page 3.)
HAND-TIGHTEN COAX CONNECTIONS. OVER-TIGHTENING CAN DAMAGE CONNECTIONS.
1. Connect one end of the supplied RG-6 coax cable to the coax port on the Tailgater.
It is recommended you use only the supplied RG-6 coax cable. (The Tailgater draws
operating power from your receiver through the coax cable.)
2. Connect the other end of the supplied coax cable to the SATELLITE IN port on your receiver.
• Do not put the Tailgater where it can be bumped into, knocked over or struck by a person
or vehicle. Do not put the Tailgater near any heat sources.
• Do not run the coax cable where it can be tripped on or run over by a vehicle.
• Do not over-tighten the coax cable connections.
• Do not put sharp bends or kinks in the coax cable.
3. Plug your receiver into a 110 volt AC power source.
The green power light on your receiver should illuminate or begin cycling on and off.
Wait for the green light to turn solid. This may take up to two minutes.
If it does not turn solid, power on your receiver using the front panel POWER button.
RECEIVER FRONT PANEL
TAILGATER OPERATION
5
GREEN POWER LIGHT