Acoustic 260 MKII Manuale d'uso - Pagina 5

Sfoglia online o scarica il pdf Manuale d'uso per Amplificatore Acoustic 260 MKII. Acoustic 260 MKII 8. Bass guitar amp heads and cabs

B300H FRONT PANEL

1. Bass Input: ¼" two-conductor jack

2. -10 dB pad: Reduces input sensitivity for use with active electronics basses or high output pickups

3. Gain: Adjusts the level of preamp input gain

4. Clipping Light: Lights in red when hi gain creates preamp clipping

5. Compression Indicator Light: Indicates the level of compression when the compressor is engaged (6)

6. Compressor On/Off: Engages compression circuitry when button is depressed

7. Overdrive: Controls the amount of overdrive

8. On/Off Switch: Activates the Overdrive circuit

9. Overdrive Level: Controls the mix of overdrive to clean signal

10. Volume: Adjusts the overall volume level of the amplifier

11. Notch: Adjusts the -10dB notch frequency from 50Hz to 1kHz.

12. Shape: This button decreases the level of the mid frequencies creating an alternate EQ curve

13. Equalizer: These 6 knobs increase or decrease the level of the associated frequency.

14. Power Switch: When lit, the amplifier is on and ready for use.

B300H BACK PANEL

1. AC power connection and Fuse: Connect included IEC power cable here. Fuse cap contains fuse for circuit protection

2. Speaker Out: ¼" speaker jack for attaching external speaker (minimum 4 Ohm total load)

3. Speaker Out: ¼" speaker jack for attaching external speaker (minimum 4 Ohm total load)

4. Direct Output: XLR direct balanced output connector jack

5. Pre/Post EQ Switch: Switches Balanced Output between pre and post EQ operation

6. Effects Return: ¼" two-conductor jack returns signal from an external effects or signal processing device

7. Effects Send: ¼" two-conductor jack sends signal to an external effects or signal processing device

8. Ground Lift: Lifts the ground from the XLR direct output. Useful for eliminating hum when the direct out is used

9. Direct Output Level: Adjusts the level of the direct output signal

10. Link In: Input from another B300H or B800H amp head. Allows user to run the B300H in Slave Mode controlled from another amp head.

This allows the user to link 2 heads together for more power and speakers controlled from one master amplifier.

11. Link Out: Output to another B300H or B800H amp head. Allows user to run the B300H in Master Mode to control another amp head.

This allows the user to link 2 heads together for more power and speakers controlled from one master amplifier

12. Footswitch: ¼" Tip, Ring, Sleeve jack for attaching optional 2 button footswitch. Controls Overdrive On/Off and Effects Loop On/Off

9779 260MKII B300H B800H B115MKII B410MKII B810MKII Owner's Manual.indd 5

260 MKII, B300H, B800H, B115 MKII, B410 MKII, B810 MKII

OWNER'S MANUAL

www.acousticamplification.com

7/13/12 4:21 PM