3D R DIY QUAD Manuale di montaggio - Pagina 4

Sfoglia online o scarica il pdf Manuale di montaggio per Quadcopteri 3D R DIY QUAD. 3D R DIY QUAD 12.

Stampa la pagina

Install motor collets

Attach a threaded collet to the top of each motor using the

four small screws included with collets. Apply threadlock to

each screw before fastening. Repeat for all four motors.

Assemble legs

Metal nuts

25 mm bolts

Leg assembly

Attach top and bottom plates

The top and bottom plates will form the main frame by attaching to your copter's arms. Align

plates in the orientation show below, and attach two blue arms to one end and two black arms

to the other using the four pairs of holes as shown.

Bottom plate

Attach black arms here

Attach blue arms here

Next add the spacers that will hold the power distribution board in place.

Using the four holes in the bottom plate shown across, align four 8 mm

spacers, and secure from the bottom using four 5 mm nylon bolts.

Slide the battery strap through the two slots in the bottom plate.

5 mm

nylon

bolts

18 mm

spacers

Place the arm between the two plates so the two holes

in the arm align with the holes in the plates. Insert a bolt

Top plate

into each hole and secure with nuts. For inner holes use

30 mm bolts and metal nuts; for outer holes use 25 mm

bolts and metal nuts. Add a rubber washer on top of the

nut on the inner holes.

For plus configuration: Attach a blue arm to only the

position on the plate marked with an arrow.

Inner holes use:

30 mm bolt + arm + metal nut + rubber washer

Outer holes use:

25 mm bolt + arm + metal nut

Your Quad has four legs, each comprised of two

landing gear pieces. To assemble each leg, align

two landing gear pieces and attach through the

three bottom holes using three 18 mm spacers

and six 5 mm nylon bolts.

For each hole, position spacer between holes,

and secure from each side with nylon bolts.

Repeat for all four legs.

Attach legs to arms with leg pointing toward

motors. Align the two top holes in the leg with

the two holes in the center of the arm. Insert

two 25 mm bolts and secure with metal nuts.

5 mm nylon bolt + 8 mm spacer

Motor collet assembly

Bottom plate