Dishlex DSF6105W Manuale d'uso - Pagina 11
Sfoglia online o scarica il pdf Manuale d'uso per Lavastoviglie Dishlex DSF6105W. Dishlex DSF6105W 16.
Stampa la pagina
•
Put back the filter (A) in the flat filter (C). Turn it clockwise until it locks.
An incorrect position of the filters can cause bad washing results and damage to the appliance
Cleaning the spray arms
Do not remove the spray arms. If the holes in the spray
arms are clogged, remove remaining parts of soil with a
thin pointed object.
External cleaning
•
Clean the appliance with a moist soft cloth.
•
Only use neutral detergents.
•
Do not use abrasive products, abrasive cleaning
pads or solvents.
Troubleshooting
If the appliance does not start or it stops during
operation, before you contact the Service, check if you
can solve the problem by yourself with the help of the
information in the table.
Problem and alarm code
You cannot activate the appliance.
The program does not start.
The appliance does not fill with water.
•
The indicator
termittently.
•
The indicator
The appliance does not drain the water.
•
The indicator
termittently.
•
The indicator
The anti-flood device is on.
•
The indicator
termittently.
•
The indicator
Once you have checked the appliance, press
problem occurs again, contact the Service.
flashes 1 time in-
flashes continuously.
flashes 2 times in-
flashes continuously.
flashes 3 times in-
flashes continuously.
Internal cleaning
•
Carefully clean the appliance, including the rubber
gasket of the door, with a soft moist cloth.
•
If you regularly use short duration program, these
can leave deposits of grease and limescale inside
the appliance. To prevent this, we recommend to
run long duration program at least 2 times per
month.
With some problems different indicators flash
intermittently and/or continuously to show an alarm
code.
•
Make sure that the mains plug is connected to the mains socket.
•
Make sure that there is no a damage fuse in the fuse box.
•
Make sure that the appliance door is closed.
•
Press Start.
•
The appliance has started the procedure to recharge the resin in-
side the water softener. The duration of the procedure is approxi-
mately 5 minutes.
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is not too low. For
this information, contact your local water authority.
•
Make sure that the water tap is not clogged.
•
Make sure that the filter in the inlet hose is not clogged.
•
Make sure that the inlet hose has no kinks or bends.
•
Make sure that the sink spigot is not clogged.
•
Make sure that the drain hose has no kinks or bends.
•
Close the water tap and contact the Service.
For alarm codes not described in the table, contact the
. If the
Service.
Possible solution
11