3D Robotics pixhawk Manuale di avvio rapido - Pagina 7

Sfoglia online o scarica il pdf Manuale di avvio rapido per Sistema autopilota 3D Robotics pixhawk. 3D Robotics pixhawk 14.

Select

Initial Setup, Install

When prompted, follow the directions to load the firmware. Once the status bar shows that the download is

complete, power cycle the board by disconnecting and reconnecting the USB.

If you hear a musical tone, your firmware installation is complete. If you hear a series of tones followed by three

beeps, disconnect the USB and reconnect while holding down the safety button. Upon restart, listen for a series

of tones followed by two beeps indicating that your firmware has loaded successfully.

Everything is OK:

musical tone

Pixhawk needs your attention:

beep BEEP beep... BEEP BEEP BEEP

CALIBRATE

With Pixhawk connected to your computer, select the communication option from the drop-down menu for

PX4

FMU, set the rate to 115200, and select the

access the calibration wizards.

Remove propellers before performing calibration.

Firmware, and select your vehicle.



Connect

icon. Select

Initial Setup

beep BEEP beep...



BEEP BEEP

and

Mandatory Hardware