Acoustic AG30 Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Amplificatore per strumenti musicali Acoustic AG30. Acoustic AG30 8. 30 watt acoustic performance amp

Stampa la pagina

1. Specifications

fRoNt pANEL

Dual combination balanced XLR and 1/4" 2-conductor acoustic instrument inputs. These two inputs may

be used simultaneously and each have their own Volume control. You may plug an acoustic instrument

and/or microphone into either channel.

Volume control. These controls adjusts the overall loudness of the individual channels of the amplifier.

If your acoustic instrument has a preamp, you should set the volume control on your instrument at about

half volume. You can then adjust the amplifier volume to your normal playing level and still have room to

increase or decrease your volume as needed from the instrument.

Low frequency control set to boost (15 dB) or cut (-15 dB) frequencies at 80 Hz. Controls the lowest

fundamental frequencies to enhance the warmth and deep, full tones of your acoustic instrument.

Midrange frequency control set to boost (15 dB) or cut (-15 dB) frequencies that you can sweep between

500Hz and 1.2kHz. Moving the midrange frequency and either cutting or boosting this frequency will

give you maximum control over the body of your tone. This control can also be useful in eliminating

acoustic feedback. It also allows you to control the definition and voice of your acoustic instrument.

High control set to boost (15 dB) or cut (-15 dB) frequencies at 10 kHz. Increasing this will enhance the

clarity and brightness of your acoustic instrument.

The Effect level control is used to determine how much of the selected effect is applied to your music.

Effect Select control allows you to select from one of 16 different effects including reverbs, delays, choruses

and combinations of the above. The 16 effects are detailed in a printed chart on the top panel of the AG30.

This 3-conductor 1/8" aux input jack will allow you to plug in a CD, MP3 player or any other source so you

can play along. To control the volume of this input, adjust the output volume of the device.

This 1/8" 3-conductor jack is for plugging in headphones. When used, it will disconnect the internal speaker.

10. The Line Out jack will provide an unbalanced, line-level signal which can be sent directly to a sound

board, live mixing console, a self-powered speaker or even another amplifier. You should always use a

1/4" shielded cable (standard guitar cable) when using this output to connect to another device.

11. Power LED. This light will illuminate with a soft blue color when the amp is turned on and

ready to play.

w w w . a c o u s t i c a m p l i f i c a t i o n . c o m