ARP Pro Solois Manuale di installazione - Pagina 6

Sfoglia online o scarica il pdf Manuale di installazione per Sintetizzatore ARP Pro Solois. ARP Pro Solois 7.

Figure 4 - Slider Assemblies Wired Into PCBs (All sliders aligned. ARP OMNI 2 shown)

for brightness adjustment of each LED.

Using a preferably non conductive jewelers screw driver, adjust the LED

brightness for each slider. If using custom colors, be sure to cut the legs

of the enclosed LEDs to the same length as the legs of the LEDs that

came mounted in the sliders. If the LED is put into the slider backwards,

that LED will not light. Reverse LED polarity if this happens. To power

the LED assembly on a Pro Soloist, connect the +V wire to J2 pin 7 (+5V) ,

and the GND wire to J2 pin 1 (0V) on Board A. The wires can be connected

anywhere along the trace connected to the aformentioned pins.

When LED assembly is prooperly powered you can adjust each slider's LED

brightness level.