Aerial AD 650 Manuale - Pagina 5
Sfoglia online o scarica il pdf Manuale per Deumidificatore Aerial AD 650. Aerial AD 650 16.
Stampa la pagina
3. Mode of functioning
The AD-air dryer is built particularly for air drying in closed rooms. That dehumidifier
can prevent the formation of condensation, eliminate too high air humidity and hold
a specific air humidity constant. The time which the dryer requires in order to
achieve a specific humidity depends essentially on the environmental conditions.
The attainable humidity value is equally dependent on the environmental conditions.
The AD-dehumidifier works according to the condensation principle with heat
recovery. The fan (shown indicatively below) suck the moist air through a cool
register (evaporator). The air becomes so far chilled under the point of
condensation here, that the moist air condense as water and flows into the water-
collecting tank. The chilled and dried air is warmed up at the condenser again.
Through the heat pump effect, the outlet air is some degrees warmer than the
sucked room air. Useful energy can conducted up to 3-fold of the electrical power
consumption. The absolute moisture of air is lowered continuously by the
continuous circulation of the room air through the device. The surplus moisture is
removed safely and efficiently.
1 – wet room air
2 – dry air
3 – evaporator
4 – condenser
5 – water tank
6 – compressor
7 – fan
4. Safety
The condensation dryers AD 5xx / AD 6xx are furnished with protective devices.
The devices were subjected to a safety examination. Dangers threaten in the case
of operating error or abuse
- for the user.
- for the machine and other real values.
- for the efficient work of the machine.
All persons who have to do with the installation, service and maintenance of the
devices must be qualified correspondingly and consider this operating manual
precisely.
Using as directed
The condensation dryers are intended for the drying of air with atmospheric
pressure.
Risk by accessory
Hoses for condensate removal and air filters must be fit expertly and must not take
the protective devices of the condensation dryers out of operation. The control
elements must always remain freely amenable.
page 5 of 15