Abbott FreeStyle Libre 2 Manuale - Pagina 4

Sfoglia online o scarica il pdf Manuale per Strumenti di misura Abbott FreeStyle Libre 2. Abbott FreeStyle Libre 2 12. Flash glucose monitoring system 4.5”
Anche per Abbott FreeStyle Libre 2: Iniziare (9 pagine), Manuale di avvio rapido (2 pagine), Iniziare (15 pagine), Iniziare (15 pagine), Manuale di avvio rapido (2 pagine)

Stampa la pagina

Applying your sensor

Follow these four easy steps to apply your sensor:

For complete application instructions, please see the product insert in the sensor kit.

* Choose a site that is at least 2.5 cm (1 inch) away from an insulin injection site. To prevent discomfort or skin irritation, you should select a different site other than the one most recently used.

† CAUTION: Do NOT use if the sensor pack or the sensor applicator seems to be damaged or already opened. Do NOT use if past expiration date. The sensor applicator now contains a needle. Do NOT touch inside the sensor applicator

or put it back into the sensor pack.

‡ CAUTION: Do NOT push down on the sensor applicator until placed over prepared site to prevent unintended results or injury.

§ Applying the sensor may cause bruising or bleeding. If there is bleeding that does not stop, remove the sensor and apply a new one at a different site. Make sure the sensor is secure after application.

Select a site on the back of your upper arm, avoiding any scars, moles, or

lumps. Wash the area with plain soap (non-moisturizing, fragrance-free) and

water, and then dry.

Use an alcohol wipe to disinfect the skin and allow the area to air-dry

before proceeding.*

Peel open the lid on the sensor pack and unscrew the cap from the sensor

applicator. Line up the dark marks on the sensor applicator and the sensor

pack. On a hard, flat surface, press down firmly on the sensor applicator until it

comes to a stop, and then lift to remove it from the sensor pack.†

Apply the sensor by placing the applicator over the cleaned site and

pressing down firmly until the sensor is in place.

applicator away from your arm and check that the sensor is secure.

Gently pull the sensor

‡