Displays2go CDSTAND2BK Manuale - Pagina 2

Sfoglia online o scarica il pdf Manuale per Supporto per TV Displays2go CDSTAND2BK. Displays2go CDSTAND2BK 3. Dual tv stand with two rotating brackets fits tvs 32” – 70”
Anche per Displays2go CDSTAND2BK: Manuale d'uso (9 pagine)

Stampa la pagina

ALL SCREWS MUST BE SECURELY TIGHTENED BEFORE USING TV STAND.

Before assembling, remove packing materials.

Carefully place the Metal Base (Part B) on a

hard, flat ground.

Ensure slot cutouts on uprights

and Lower Tubes align with

each other.

Fix Lower Tubes by tightening 4 screws at

bottom of the TV Stand.

Still have questions? No worries. If you're confused during any step, just call the number located at the

bottom of the Instruction pages. Our friendly representative will be more than happy to assist you.

55 Broadcommon Road Bristol, RI 02809, USA

FLAT BASE TV STAND

Holes at top of Lower Tubes should

face outward, to align with the holes on

Tube Connectors. (See STEP 4)

Insert Lower Tube into the upright on

the Metal Base.

Tighten 4 Screws (Part F) against the

surface of lower poles with hex key.

Fix Tube Connector (Part E) on top of the

Lower Tube.

Insert Upper Tubes with Connectors.

Ensure the 2 slot cutouts are facing

the same direction as other cutouts

on the Lower Tubes.

Insert Upper Tubes (Part D) intoTube

Connectors from above. The holes should

line up with the holes on Connectors.

Fasten 4 Screws (Part F) with hex key.

If securing the whole unit to the floor,

use hardware through 4 corner holes

to fix the base.

Phone: 1-800-572-2194 1-401-247-0333 (Int'l) Fax: 1-401-247-0392

Insert Tube Connectors (Part E) into the

Fixed Lower Tubes. Hold it in place when

lining up holes. (Align with the top holes on

Lower Tubes)

Insert 4 Screws (Part F) through Lower

Tubes into Connectors. Fasten screws

with hex key.