3D Systems ZPRINTER 250 Manuale di avvio rapido - Pagina 10

Sfoglia online o scarica il pdf Manuale di avvio rapido per Stampanti 3D 3D Systems ZPRINTER 250. 3D Systems ZPRINTER 250 16.

6.5 Clean the Parking Caps

(ZPrinter 250 Type 1 only)

Note: Parking caps are only installed on older ZPrinter 250 mod-

els (Type 1). On more recent ZPrinter 250 (Type 3) and on all

ZPrinter 150 models, the Parking Caps are not present.

Before you begin:

•

Get several dry paper towels and a cotton swab.

•

Get the squirt bottle filled with distilled water.

•

Wear disposable gloves.

•

Get the Pick and Syringe from the Accessories Kit.

Lift the Parking Cap cover to a horizontal position and place

dry paper towels underneath.

Squirt the distilled water onto the caps. Do not squirt water

onto the Build Bed.

3dscentral.3dsystems.com

Use a cotton swab and dry paper towel to wipe the caps

clean. Use the pick if needed to remove any powder.

Remove the paper towels from under the caps and wipe up

any excess water on the deck.

Be sure the Parking Caps are completely dry before starting

your next build.