Abbra Home Control Manuale di avvio rapido - Pagina 14

Sfoglia online o scarica il pdf Manuale di avvio rapido per Sistema di sicurezza Abbra Home Control. Abbra Home Control 20. For abbra home control; abbra campus; abbralink
Anche per Abbra Home Control: Manuale di avvio rapido (8 pagine)

Stampa la pagina

Zone Low Batteries (Z01 Low Battery, Z02 Low Battery, etc.)

Like the tamper alarms, the Abbra detects if a sensor has a low battery. The batteries in the

sensors do not recharge themselves, and should be replaced every so often. Use only the

battery described in the sensor's instructions.

Line Failure

This means that there is no phone line connected to the Abbra control panel. To fix this

problem, simply ensure that a phone cord is securely plugged into the SET phone jack on the

back of the control panel.

Communication Failure

This means that the Abbra attempted to send a signal to the monitoring center or call a

private phone number programmed into it, but could not get through. There are several

reasons this might occur.



If you have programmed private phone numbers into the system, such as your cell

phone number, double-check all the numbers to ensure they are correct.



If the Abbra also says Line Failure, ensure that the phone cord is securely plugged

into the SET phone jack on the back of the panel.



If you have recently picked up the phone and heard the Abbra trying to dial or

communicate, then most likely that signal was disrupted. When the Abbra is

communicating, it will sound like a fast series of tones, like someone is pressing

buttons on a touchtone phone very quickly. Simply hang up the phone and wait a

few minutes, and the Abbra will try again. If this occurs often, we recommend wiring

the Abbra to an RJ31X connection, which will allow the Abbra to disconnect your

phones while it is communicating.



If the Abbra is monitored over a standard phone line, make sure your phone line is

operational. If your phones are out, then the system cannot communicate.



Likewise, if the Abbra is monitored over the Internet using an ABN adapter, make

sure your Internet connection is working. If your Internet connection is down, then

the system cannot communicate over ABN.



If the Abbra is monitored over the Internet, and your Internet connection is working,

see the ABN Connection Tips page for more help.

Once you have fixed the problem, you will need to force the Abbra to attempt another

communication. The quickest way to do this is to place the system in its test mode, by

pressing #, then typing in the installer code or the first user code. The siren will sound for

about one second. After it stops, press AWAY then VIEW/SELECT to exit test mode. The

system will communicate these events to the monitoring station, and if it is successful, the

communication failure will be resolved.

Alarm – When Abbra detects that a zone has been disturbed, it will trigger an alarm. The

siren will sound, and an alarm signal will be sent to the Central Station.

List of Terms

(in alphabetical order)