Distech Controls GS-CDR02K Manuale di installazione dell'hardware - Pagina 2
Sfoglia online o scarica il pdf Manuale di installazione dell'hardware per Trasmettitore Distech Controls GS-CDR02K. Distech Controls GS-CDR02K 9. Room carbon dioxide transmitter
Stampa la paginaMounting Instructions
The transmitter installs directly on a standard electrical box and should be mounted five feet from the floor of the area to be controlled.
Do not mount the sensor near doors, opening windows, supply air diffusers or other known disturbances. Avoid areas where the
detector is exposed to vibrations or rapid temperature changes. Prevent measurement errors by sealing the wall or conduit openings
to prevent air migration from the wall cavity.
The cover is hooked to the base at the top edge and must be removed from the bottom edge first. Use a small Phillips screwdriver to
loosen the security screw as shown in Figure 2. Complete removal of the screw is not required. Use the screwdriver to carefully pry
each bottom corner if necessary. Tip the cover away from the base and sit it aside as shown in Figure 3.
Figure 2. Loosening the security screw
Figure 3. Removing cover plate
The PCB must be removed from the base to access the mounting holes. Follow anti-static procedures when handling the PCB and
be careful not to touch the sensors.
The PCB is removed by pressing the enclosure base to unsnap the latch near the bottom edge, then the PCB can be lifted out of the
base as shown in Figure 4.
Figure 4. Lifting PCB from enclosure base
Sit the PCB aside until the base is mounted on the wall. For added protection, place the PCB in the supplied anti-static bag.
2/9