Acoustic Energy Aelite Manuale d'uso - Pagina 3

Sfoglia online o scarica il pdf Manuale d'uso per Altoparlanti Acoustic Energy Aelite. Acoustic Energy Aelite 4. Custom install series
Anche per Acoustic Energy Aelite: Manuale d'installazione e d'uso (8 pagine)

Stampa la pagina

Check that your amplifier is switched off before installing your

loudspeakers. Failure to do so may result in speaker or amplifier

damage. The diagram illustrates one loudspeaker only.

Conventional

Normal passive wiring requires shorting links to be in place between the

treble and mid/bass sections. The positive (ribbed) cable from the

amplifier positive (or red) terminal should connect with the positive

(red) terminal on the loudspeaker. Similarly the negative (smooth) cable

should connect the amplifier negative terminal (black) to the negative

terminal (black) on the loudspeaker.

Bi-wiring

Bi-wiring separates the bass and treble ground paths in the loudspeaker

and offer sound quality advantages. An extra set of cables is required.

Note that the shorting links are removed between the treble and

mid/bass sections and should be stored for later use if conventional,

passive driving is required.

Two pairs of cables are connected to the amplifier terminals. One cable

of each pair should connect to the treble section and one to the

mid/bass section. The positive (ribbed) cables from the amplifier positive

(or red) terminal should connect with the positive (red) terminals on the

loudspeaker. Similarly the negative (smooth) cables in each pair should

connect the amplifier negative terminal (black) to the negative terminals

(black) on the loudspeaker.

Bi-amping

Bi-amping adds a second amplifier to the system. One power amplifier

drives the treble section of both loudspeakers; a second drives the

mid/bass sections. Note that the shorting links must be

removed. Failure to do so will result in damaging the

amplifiers.

As regards the loudspeakers, wiring for bi-

amping is achieved in much the same way

as bi-wiring. Treble amplifier positive (red)

terminals should be connected via the

ribbed cable to

the positive (red) HF terminal on the speaker.

Similarly, treble amplifier negative is

connected to the negative (black) HF

terminal on the speaker. Repeat this

process with the mid/bass amplifier

and LF terminal pair.

After wiring up

Lower the volume to the minimum,

switch on the amplifier, select the signal source and

then raise the

volume to the listening level

required.

Connection

LEFT SPEAKER

RETAIN LINKS

FOR FUTURE USE

AMPLIFIER

MAIN