3D Upfitters LulzBot Mini 2 R1 Manuale di installazione - Pagina 10

Sfoglia online o scarica il pdf Manuale di installazione per Stampanti 3D 3D Upfitters LulzBot Mini 2 R1. 3D Upfitters LulzBot Mini 2 R1 18. Enclosure kit

Stampa la pagina

5. Attach Left Side

Be careful when handling the left side with the

cut-out section so as to not twist the longer

sections.

Attach the corner connectors and the mid-corner

connectors to the left and right sides of the panel.

Do not attach the top-middle connector as that will

be done when assembling the top. Finally, attach

the entire left side panel to the front as shown.

For all of the sides use M4 12mm screws and

nuts.

6. Assemble Back

The view to the right is of the back of the enclosure

when viewed from the back. The four corner

connectors are mirror images of the front and are on

the other side of the plastic in this view. The large

hole is either for an air ﬁlter (purchased separately) or

can be covered up by a plastic disc using short M4

12mm screws. On the top and on each side are "mid

panel corner connectors", which are basically simple

L-shapes.

If assembling the Charcoal Air Filter, conﬁrm the direction of the

fan's air ﬁlter by plugging it into a USB power supply before