3D Upfitters AnkerMake M5 Manuale di installazione - Pagina 10

Sfoglia online o scarica il pdf Manuale di installazione per Involucro 3D Upfitters AnkerMake M5. 3D Upfitters AnkerMake M5 18.

If you haven't purchased an air ﬁlter or vent kit you'll want to

install the fan at this point. If you have purchased one of

those accessories you can skip this step.

Ensure the fan is blowing air out of the enclosure and NOT

into it. Conﬁrm the fan's direction by plugging it into a USB

power supply before attaching the ﬁlter. The round label

should be on the outside.

The fan should be attached to the outside of the

enclosure.

The fan should be oriented to pull air OUT of the enclosure.

Use the long screws included in the fan packet to attach the fan. The length of the

screws may change depending on the depth of this

particular shipment of fans.

The back panel also contains the removable grommet

cable portal. Locate the grommet and insert it into the

grommet holder. This is where you'll insert the power

cable, USB cable, and wires you want to run in or out

of the enclosure.

Insert the grommet holder/grommet combination into

the U-shaped hole in the right-side panel. This will enable

you to slide the enclosure oﬀ and onto the printer without

unplugging the cables.