3D Upfitters AnkerMake M5 Manuale di installazione - Pagina 7

Sfoglia online o scarica il pdf Manuale di installazione per Involucro 3D Upfitters AnkerMake M5. 3D Upfitters AnkerMake M5 18.

The front should look like the picture below:

Locate the magnetic latches and use the wood screws to

attach them to the latch mount shown to the right. The

magnetic metal strips should be facing out of the enclosure.

Hand tighten only enough, so the magnetic latch doesn't

move, as the latch will be later adjusted front-to-back to

ensure the door is ﬂush with the frame.

Each latch mount is attached via three screws. Use the

30mm cap head to secure the latch mount inside the door

frame. You'll use 2 M4 12mm screws to attach the latch

mount to the right-side panel later in the assembly.

Attach the hinges to the outside door and door frame using

M4 12mm screws and nuts. There will be some play in the

hole size so that you can adjust the door to swing freely.

Attach the doorknob by ﬁrst inserting the square M4 nut into the

slot. Use a 16mm cap head screw to attach the door.

Now that the latches are mounted, it is time to connect the strike

plate. Each plate has a squishy adhesive covering the same size as

the plate. Carefully attach the adhesive side to the acrylic at the

location of each latch. Then, adjust the width of the metal strike

plate so that it is held on by the pressure of the two sides of the