3DGence DT3 Manuale - Pagina 4

Sfoglia online o scarica il pdf Manuale per Stampanti 3D 3DGence DT3. 3DGence DT3 14.

Installation

1. Selecting a location

Select a clean, dry, well-lighted area with a

minimum clearance of six inches between the

3DGence DT3 and any adjacent walls. It is espe-

cially important to select a level surface, due to

liquid levels in the tank. The ideal room temperatu-

res for the system are between 18C and 21C.

2. Power requirements

3DGence DT3 requires 230vac, 50/60Hz, 10amp

service. As a normal industry safety practice, a

ground fault interrupt outlet must be used.

Figure 2

3DGence DT3

3. Connecting the drain

The 3DGence DT3 drain is located at the rear of the

unit (see Figure 2). Install a standard 19mm inside

diameter hose to the 19mm barbed ﬁtting attached

to the drain valve.

4. To operate the system

Please review the previous section entitled "Rules

for Safe Operation", then proceed to the next

section "Operation".

drain valve

(shown shut)

Jet action cleaning