Altman Spectra-STAR PAR SS-SPP-100 Manuale di installazione e istruzioni - Pagina 4

Sfoglia online o scarica il pdf Manuale di installazione e istruzioni per Riflettore Altman Spectra-STAR PAR SS-SPP-100. Altman Spectra-STAR PAR SS-SPP-100 11. Solid state lighting fixture spectra-star par series

Stampa la pagina

I N S T A L L A T I O N

A N D

I N S T R U C T I O N

M A N U A L

SETUP AND INSTALLATION

Unpacking

Remove the LED lighting fixture from its shipping box. Set the unit down on a flat surface before proceeding.

Lamping and Re-lamping

The LED lighting fixture is provided with an integral LED light engine. Under normal operating conditions,

the LED light engine should have a rated life expectancy of over 50,000 hours. There are no user serviceable

parts inside. The entire LED assembly will need to be changed.

Mounting the fixture

For ceiling mounting, install the Yoke and a Pipe Clamp if desired. Loosen the bolt on the pipe clamp mounted

on top of the fixture yoke until the clamp fits snugly around the mounting pipe. Make sure the clamp wraps

securely around the pipe surface. Tighten up the bolt securely to the pipe. Next, loop the safety cable around

the pipe and yoke, and then clip it back onto the cable itself. For stand mounting, remove the Pipe Clamp and

rotate the Yoke to the bottom of the fixture. Secure the Yoke to the stand with a bolt and washer. For floor

mounting, use a weighted base suitable for securing the yoke and fixture to it and not allowing the fixture to fall.

For outdoor use, it is recommended to mount the fixture with the keypad on the underside to prevent

accumulation of dirt, water, bird droppings, etc. If track mounted, install track adapter into lighting track.

Connecting power to the fixture

Plug the fixture into a grounded receptacle connected to a circuit breaker. Connect DMX signal to the fixture.

Focusing the fixture

With the fixture energized, point the unit in the direction of the object to be illuminated. Adjust the yoke or

feet to the desired position and secure the fixture with the two handles provided on either side of the yoke.

Remove lens holder and insert a desired beam spread lens into the holder and snap ring back into the front of

the fixture. The top knob locks the lens ring and prevents it from rotating once the desired focus is achieved.

Cleaning the fixture

Routine cleaning of the SS-PAR-100 lighting fixture will provide years of prolonged use. Use compressed air to

blow off any dust and dirt from the lens, reflector, electronics and heat sink. For the lens, use a soft lint-free

cloth dampened with water to clean the lens of dust and dirt. Dry off completely with compressed air or a dry

lint-free cloth.

ETL FILE LISTING

The SS-SPP-100 and SS-SPY-100 lighting fixture is ETL and c-ETL pending under Altman File 9700680 for

Portable Electric Luminaires (UL Standard 153) and Surface Mount Luminaires (UL Standard 1598).