Alto FLEX plus Manuale d'uso - Pagina 8

Sfoglia online o scarica il pdf Manuale d'uso per Apparecchiature di registrazione Alto FLEX plus. Alto FLEX plus 14. Sound enhancement processor

The fuse-holder above the AC connector on the rear of the chassis has 3 triangular markers(please refer

to the above pictures), with two of these triangles opposing each other, your unit is set to the operating

voltage printed next to these markers.

To change, pull fuse-holder out and rotate 180 , then push in again.

17.AC Inlet

This connector is used to connect the supplied power cord. Please don't plug power cord into this unit

and AC power if voltage has not been correctly set.

18. Audio In

These connectors are used to input the signal source. You can input the signal via the balanced 1/4" TRS

phone jack or XLR connector.

19. Audio Out

These connectors are used to output the signal source. You can output the signal via the balanced 1/4"

TRS phone jack or XLR connector.

4. INSTALLATION AND CONNECTION

FLEX plus is provided with dual voltage plug. You must check the power supply voltage available in your country

before connecting the power cord in the wall outlet.

The FLEX plus Sound Enhancement Processor is equipped with balanced XLR connectors as well as 1/4" phone

jack and can be connected with other units in different ways to support a vast range of applications without

experiencing a signal loss.

a. Wiring Configuration

Both types of connectors available on FLEX plus can be wired in balanced and unbalanced modes.

Please see following drawing for details.

For 1/4" Phone jack

TS Type Unbalanced

220-240V

THIS IS SET FOR

110V AC TO 120V

AC OPERATION

Tip

Sleeve

THIS IS SET FOR

220V AC TO 240V

AC OPERATION

Tip

Ring

Sleeve

TRS Type Balanced

110-120V

Tip

Ring

Sleeve

TRS Type Unbalanced