Alto L-6 Manuale Ownes - Pagina 13
Sfoglia online o scarica il pdf Manuale Ownes per Apparecchiature di registrazione Alto L-6. Alto L-6 19. 6-channel mixing console with digital effects
Stampa la pagina5. INSTALLATION AND CONNECTION
Ok, you have got to this point and you are now in the position to successfully
operate your L-6. However, we advise you to read carefully the following
section to be the real master of your own mix. Not paying attention enough to
the input signal level, to the routing of the signal and the assignment of the
signal will result in unwanted distortion, a corrupted signal or no sound at all.
So you should follow this procedure for every single channel:
1. Turn down all Input and Output Gain Controls.
2. Connect phantom powered microphones before switching on the +48 Volt
phantom power switch.
3. Set the output level of your L-6 or the connected power amplifier at no more
than 75%.
4. Now, set the CONTROL ROOM/PHONE level at no more than 50%.
5. Position HI, MID and LOW EQ controls on middle position.
6. Position panoramic (PAN/BAL) control on center position.
7. With a pair of headphones or studio monitor speakers connected apply a
Line Level input signal so that the PEAK LED does not light up.
8. While speaking into the microphone (or playing the instrument), adjust
the channel level control so that the PEAK LED will blink occasionally, in
this way you will maintain good headroom and ideal dynamic range.
9. Now repeat the same sequence for all input channels. The Main LED
Meter could move up into the red section. In this case, you can adjust
the overall output level through the MAIN MIX control.
Audio Connections
You can connect unbalanced equipment to balanced inputs and outputs. Simply
follow these schematics.
Strain Clamp
Strain Clamp
Ring=Right Signal
Tip
Sleeve
Ring
Sleeve=Ground/Screen
Use for Headphone, Stereo Return
1/4" Stereo (TRS) Jack Plug
Tip
Sleeve
Sleeve=Ground/Screen
Use for Mono Line In, Mono 1/4"Jack Plugs
1/4" Mono (TS) Jack Plug
Tip=Left Signal
Tip=Signal
11