Acoustic Research AW822 Manuale di installazione e funzionamento - Pagina 11

Sfoglia online o scarica il pdf Manuale di installazione e funzionamento per Sistema di altoparlanti Acoustic Research AW822. Acoustic Research AW822 13. Wireless indoor/outdoor speaker with auto-tuning

Stampa la pagina

1. Connecting the Speaker System

Troubleshooting

The following troubleshooting guide takes you through some of the more common

problems associated with the installation and/or operation of a wireless system. If the

problem persists, please call toll-free at 1-800- 732-6866 or visit www.araccessories.com.

Issue:

Cause and solution:

No sound

• Check that the transmitter AC power adapter is fully inserted into the wall outlet

• Confirm that the speaker is turned on and tuned to the transmitter—

• If you're using the power adapters, confirm that both (for the speaker and for the

• If you're using batteries, check that they are fresh and inserted with correct

• Check that the audio source component (stereo, TV, etc.) is turned on and

• Check that the speaker volumes are turned up.

• If you are using a Tape 2 Monitor output from your receiver/amp as the audio

Issue:

Cause and solution:

No sound/

• When using battery power, make sure the batteries are fresh and replace if

distortion/

static

• Check that the speaker STDBY./TUNED indicator is illuminated blue.

• Change the position of the channel select switch (1, 2 or 3) to change the

• Change the location of the transmitter. Place it as high and away from

• Move the transmitter and speaker closer together. Sending the signal through

and the power cord from the AC adapter is firmly connected to the transmitter

power input jack.

the STDBY./TUNED indicator light on the front of the speaker should be

illuminated blue.

transmitter) are fully inserted into their wall outlets and the adapter power cords

are firmly connected to the power input jacks on the transmitter or speaker.

polarity (+, –).

transmitting sound as it normally should.

output, check that you have pressed the Tape Monitor/Tape 2 button on the

front of the receiver. This will turn on the Tape 2 outputs, which may not have

been active.

necessary.

operating frequency. The speaker will detect the loss of signal and retune

automatically. You can also press the ON/OFF/TUNING/VOL. control up once

to make the speaker retune.

obstructions as possible. Avoid placing the transmitter directly on top of or

behind a TV.

certain materials, such as glass, tile, and metal, can decrease the effective

transmitting distance of the system.