Alto Professional APX1500 Manuale di avvio rapido - Pagina 3
Sfoglia online o scarica il pdf Manuale di avvio rapido per Amplificatore Alto Professional APX1500. Alto Professional APX1500 8.
Stampa la pagina
REAR PANEL DIAGRAM
PUSH
3
4
COOLING FAN- This fan secures cooling for the amplifier. The airflow is from front to rear. The fan speed is
1.
electronically regulated depending on the temperature of the power devices. Do not block these fan grills or
mount the amplifier in an enclosed rack, which could cause the amplifier to overheat.
LOW PASS FILTER – This switch activates the built-in low cut filter. All audio below 30 Hz will be removed
2.
from the output signal.
BALANCED COMBO INPUTS – Connect your mixer to the balanced XLR or balanced 1/4" input for that
3.
channel.
OUTPUT MODE SWITCH –
4.
modes:
Stereo Mode
In this mode, CH 1 and CH 2 operate independently (as a normal
stereo amplifier) The CH 1 input signal will be output from the CH A
output connector, and CH 2 input signal will be output
from the CH 2 output connector.
Parallel Mono Mode
In this mode, CH 1 input signal will be output from the
output connectors of both
channels.
Bridged Mode
In this mode, CH 1 input signal will be output from the
bridge-mono output connector.
CHANNEL OUTPUTS – Connect your speakers' input
5.
jacks to these outputs.
•
For the binding posts, red is the positive signal and
black is the negative signal.
respect the speaker polarity when using binding
post. Turn off the unit before connecting an audio signal to the binding post to avoid any electric shock!
•
The SPEAKON outputs
is secured automatically. They prevent shock hazard and they lock-in securely.
POWER IN – Connect the cable to a standard wall outlet. Be sure the supplied voltage matches the required
6.
voltage of the amplifier. Do not connect the amplifier to an outlet that does not match the required voltage;
doing so could damage the amplifier.
PUSH
3
1
2
The APX 1500 presents three operating
Please make sure to
are specifically designed to connect to high power speakers. The correct polarity
5
5
5
WARNING!:
STEREO/MONO BRIDGE SWITCH when the
amplifier is on
WARNING!: Do not allow any wires of
adjacent terminals to come in contact with each
other.
Also, do not connect either positive
(red) output to chassis ground.
3
5
6
How do I know if my 1/4" cables
are balanced?
BALANCED
UNBALANCED
Do
not
adjust
.
the