Balteco Rego Manuale d'uso - Pagina 3
Sfoglia online o scarica il pdf Manuale d'uso per Prodotto idraulico Balteco Rego. Balteco Rego 8. Xonyx solid surface
Stampa la pagina2.3.
INSTALLATION
Product should be leveled using the adjustable legs. Adjust the legs to achieve the required
•
height and level the product horizontally. Fasten the legs with counter nuts.
Fill in the spaces between the product and the wall with silicone sealant if necessary.
•
In the case the product is walled into the bathroom it is important to allow the maintenance of
•
the product and, where necessary, its removal. When walling up a product, leave a sufficient
ventilation space into the wall.
2.4.
WATER CONNECTION REQUIREMENTS
Products drainage tube should be connected with the drainage system with flexible hose.
•
Product has drainage tube with diameter of 40 mm.
•
The product's drainage system is designed for connecting to self flowing household drainage
•
system. The drainage rate corresponds to standard drainage rate of bathtubs and shower
cabins drainage rate - 0,9 l/sec. Drainage tubes must be designed and installed with tilt that
guarantees self cleaning of the drainage tubes – i = 0,02...0,03.
PS! While installing a bath mixer, connect the mixer with earthing bars of the product's frame,
•
using wire of 2,5 mm² of cross section.
When installing a bath mixer to a bath which has a massage system (S11), make sure to install
•
the mixer with a bath frame ground terminal using a protected copper wire with a 2,5 mm
larger, cross-section.
Xonyx™ solid surface baths and shower trays are finished with a silky surface finish. Xonyx™ is a very
durable product that will last for years with simple care. Follow the recommendations below to
properly clean Xonyx™ solid surface product.
3.1.
EVERYDAY CARE
It is recommended to clean the bathtub/shower cabin immediately after every use with
•
thorough rinse of warm water and dry with soft and dry cloth to avoid water stains.
Washing with soap or hand dishwashing liquid and water is usually sufficient to remove surface
•
dirt or stains.
Upon need of thorough cleaning wide variety of bath cleaning sprays sold with safety labelling
•
allowing the cleaning of such surface or commercially available solid surface cleaners are
effective.
Drying is an important step, preventing a build-up of soap film or cleaning residue, which can
•
create the appearance of light scratches over time.
3.
MAINTAINANCE
2
, or