Camfil AIR IMAGE Manuale d'uso
Sfoglia online o scarica il pdf Manuale d'uso per Accessories Camfil AIR IMAGE. Camfil AIR IMAGE 2.
Stampa la pagina
IMPORTANT SAFETY INFORMATION
Warning! The Air Image Sensor may not be used outside or in wet
environments. Clean the sensor carefully with a dry cloth. NEVER
use pressurized air to clean the sensor.
•
Do not cover the sensor
•
Keep the sensor away from water, it is not waterproof
•
Avoid having thick walls between the sensor and the
Air Cleaners
If the equipment is used in a manner not specified by the manu-
facturer, the equipment functionality may be impared. Always use
original power supply, recommended by Camfil.
PLEASE NOTE!
Due to electric components and local restrictions for disposal,
the sensor and its components must always be sent to a recycling
station for correct recycling.
TECHNICAL DATA
Power supply:
Supplied USB Power Supply
Voltage 5 V/DC
Amps 2 A
Consumption 10 W
Operating range particles: PM1 and PM2,5
Operating range RH:
0 to 100 not condensating
o
Operating range temp:
-10 to 50 C
Dimensions (W x H x D):
144 x 64 x 61 mm
Weight:
200 gr
DESCRIPTION
FRONT
On/off
Pairing SIM card
BACK
Outlet
(Do not cover)
TOP
Light symbols indicating that the sensor:
Is connected
to one or
more Air
Cleaners
Is turned on
Has a mobile connection
(When the bars are lit in a steady green
colour, it means that the sensor is
receiving the mobile signal.)
2
POWER SUPPLY
Step 1:
Choose the pin configuration suited to your region's outlet type.
Step 2:
Slide the pin-plug into the groove of the power adapter.
Step 3:
Connect the power cord to the sensor and a power outlet.
INSTALL THE SIM CARD
(Only for units without pre-installed SIM card.)
Normally the SIM card is supplied with the unit, if not please do
the following:
Step 1:
Install the SIM card in the slot to the left of the power jack.
Step 2:
When these two light symbols stop blinking after about a
minute, it means that the sensor is connected to the internet.
Inlet
(Do not cover)
Power jack
Data sent from sensor to internet
Step 3:
Press the power button.
Press
Step 4:
The power symbol lights up.
Is uploading
data to the
internet
3
Sensor connected to internet
Power symbol
www.camfil.com
CREATE A WEB ACCOUNT AND ADD THE SENSOR
Step 1:
Go to
airimage.camfil.com
1. Log in to your account.
2. Create a new account.
Step 2:
When the sensor system is connected to the internet and you have
created an account, use your Air Image serial number and access
code to add your sensor to the account.
Login: xxx
Password: xxx
PAIRING THE SENSOR WITH YOUR AIR CLEANERS
Step 1:
Press the pairing button on the Air Cleaners to connect them to
the sensor system – hold the button until the LED light blinks.
Step 2:
Press the pairing button – second from the left – for 3 seconds.
Press
Step 3:
When the Air Cleaners and the sensor are paired, the symbol with
the two linked squares will light up on top of the sensor.
Air Cleaners paired with sensor
4
Pairing button on
Air Cleaner units
C L E A N A I R S O L U T I O N S