3DUpFitters CR-10 Smart Enclosure Kit Manuale di installazione - Pagina 8

Sfoglia online o scarica il pdf Manuale di installazione per Stampanti 3D 3DUpFitters CR-10 Smart Enclosure Kit. 3DUpFitters CR-10 Smart Enclosure Kit 19.

Stampa la pagina

Mid-panel connectors are used to secure the middle of the

panels.

When you remove the front door, be sure to remember the orientation, i.e. which

part of the door is the inside and outside. You'll want to attach the door the same way

it was taped. The reason is the laser cuts at a small angle, so if you insert the door

backwards this can create interference making it diﬃcult for the door to swing properly.

The front should look like the picture to the right.

Note again that the connectors are on the inside of

the enclosure. 

2. Assemble Front Door 

Locate the magnetic latches and use the wood screws to

attach them to the latch mounts. Hand tighten and make sure

they're secure, but do not over tighten or they may strip. The

latch can be later adjusted front-to-back to make sure the

door is ﬂush with the door frame.

Each latch mount is attached via three screws. Two M4

12mm cap heads are used to attach the latch mount to the

side, while a 30mm cap head secures the latch mount to

the door frame.

Attach the hinges to the door and door frame using M4

12mm screws and nuts. There will be some play in the hole

size so that you can adjust the door to swing freely.