3DUpFitters Ender 3 V2/CR-6 Enclosure Kit Manuale di installazione - Pagina 8

Sfoglia online o scarica il pdf Manuale di installazione per Stampanti 3D 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit. 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit 15.
Anche per 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit: Manuale di installazione (16 pagine)

Stampa la pagina

2. Left Side Panel

Attach the left side to the front forming an L-shape

that will stand up on its own, then attach one L and

one R connector at the back.

The Ender 3/Pro design adds a side door for easy

access to the extruder. The latch mounts are smaller

than the front, although the magnetic latch attaches

in the same way with wood screws. The parts for the

side door will be in a separate packet.

Attach the door hinges, latch mounts, strike plates,

and the knob, and the assembly will look like the illustration

to the right. Don't forget the mid-panel connectors at the

back left and top.

As with the front door, adjust how the door hangs by

loosening the hinge screws, using the strike plates to hold

the door to the latches, and then tightening the hinge

screws.

Note that the left side will also be the location of the fresh air intake vent, but that will

be installed after the enclosure is placed over the printer.

3. Back Panel

The back of the enclosure is shown to the right. The four corner connectors are mirror

images of the front. The large hole is either for an air ﬁlter (purchased separately) or

can be covered up by the included plastic disc using M4 12mm screws. On the top

and on each side are "mid panel corner connectors", which are basically simple L-

shapes.

Make sure the fan is blowing air out of the enclosure and NOT into it.