esera automation 11319 Istruzioni per l'uso - Pagina 3
Sfoglia online o scarica il pdf Istruzioni per l'uso per Controllore esera automation 11319. esera automation 11319 4. 1-wire controller 1 ethernet w/auto-e-connect
Anche per esera automation 11319: Manuale d'uso (9 pagine)
Stampa la pagina
Art No 11319
8
Connetion
Modul topside (1-Wire Bus)
7 = GND
8 = 1-Wire Data
9 = + 5V Output
Modul buttom side (supply voltage)
1 = Minus supply voltage
2 = Plus supply voltage
9
Operating conditions
The operation of the assembly group can take place only on condition of observing the required voltage and the
ambient conditions. The operating position of the device is irrelevant. The device is meant to be used in dry or
humid areas.
Should condensed water build up within the sensor, an acclimatisation period of at least 2 hours must pass.
Assembly groups and components do not belong into the hands of children!
The building group can be operated only under the supervision of an electrically skilled person.
In industrial facilities, the accident prevention regulations of the federation of industrial professional associations for
electrical installations and equipments must be observed.
Do not operate the assembly group in an environment with inflammable gases, vapours or dusts or in an
environment where such gases, vapours or dusts may be found.
10
Assembly
The mounting place must be protected against moisture. The module may only be used in dry indoor rooms or in
protected outside areas. The device is designed for fixed installation within a switching cabinet.
11
Disposal Note
Do not dispose of this device in the household waste. Electronic devices must be disposed of in
accordance with directives for disposing of waste electrical and electronic equipment at local
collection points for electronic waste material.
12
Safety Instructions
When using products that come into contact with electrical voltage, the valid VDE regulations must be observed,
especially VDE 0100, VDE 0550/0551, VDE 0700, VDE 0711 and VDE 0860
All final or wiring work must be carried out with the power turned off.
Before opening the device, always unplug or make sure that the unit is disconnected from the mains.
Components, modules or devices may only be put into service if they are mounted in a contact proof housing. During
installation they must not have power applied.
Tools may only be used on devices, components or assemblies when it is certain that the devices are disconnected
from the power supply and electrical charges stored in the components inside the device have been discharged.
Live cables or wires to which the device or an assembly is connected, must always be tested for insulation faults or
breaks.
If an error is detected in the supply line, the device must be immediately taken out of operation until the faulty cable
has been replaced.
When using components or modules it is absolutely necessary to comply with the requirements set out in the
accompanying description specifications for electrical quantities.
All rights reserved. Reprinting,, also in excerpts, without prior permission of ESERA and E-Service GmbH prohibited. Technical changes
reserved. ESERA E-Service GmbH 2016
www.esera-automation.de
11319 Manual 1-Wire Controller 1 ETH V2.2
Page 3 von 4