3DUpFitters FT-5 Enclosure Kit Manuale di installazione - Pagina 11

Sfoglia online o scarica il pdf Manuale di installazione per Stampanti 3D 3DUpFitters FT-5 Enclosure Kit. 3DUpFitters FT-5 Enclosure Kit 16.

Rear Panels

1. Loosen the Right Rear Corner Braces

Following the same procedure as with the front, loosen the t-nuts on the braces

securing the right-rear corner braces. This will give access to insert both the rear and

right-side panels.

2. Top Rear Panel 

The rear panel has an access circle that by default is covered by a circular plastic

cover which is attached via M5 8mm screws. If you purchased the optional ﬁlter/fan

options do not attach the cover. Note that the access hole can be placed on either

side. Remember to cut and place the rubber trim pieces to avoid rattling.

FT-5 Back View