3DUpFitters Prusa i3 MK3 Manuale di installazione - Pagina 7
Sfoglia online o scarica il pdf Manuale di installazione per Stampanti 3D 3DUpFitters Prusa i3 MK3. 3DUpFitters Prusa i3 MK3 11. Enclosure kit
Anche per 3DUpFitters Prusa i3 MK3: Manuale di installazione (18 pagine)
Stampa la pagina2. Attach Left Side
The left panel is distinguishable by its
small hole for a cable grommet, in
addition to having "left side" written on
it. Insert the grommet as pictured
before attaching the front of the left-
side to the door frame.
3. Assemble Back
The view to the right is the back panel of the
regular Prusa enclosure when viewed from
behind. The MMU2S version adds two rubber
grommets (not shown) for the PTFE tubes to fit
through.
The four corner connectors are mirror images of
the front.
On the top and on each side are "mid panel
corner connectors", which are basically simple
L-shapes.
The large hole is either for a fan by itself, an air filter (purchased separately)/fan combo,
or it can be covered up by a plastic disk depending on how much air flow you want.
Note that the fan, either by itself or paired with the filter or vent is necessary to draw air
over the power supply. This both heats up the air inside the enclosure AND cools
down the power supply, which extends its life. Only use the circular disk to cover up
the hole if you have moved the power supply
outside of the enclosure, or if you simply don't
care about power supply longevity.
Confirm the direction of the fan's air filter by
plugging it into a USB power supply before
attaching to the filter and back of the enclosure.
The fan should be oriented to pull air OUT of
Copyright 2018 3DUPfitters
7