Division 6 Dual Mini Sequencer Manuale di istruzioni per l'uso - Pagina 4

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Sintetizzatore Division 6 Dual Mini Sequencer. Division 6 Dual Mini Sequencer 14.

Of course, if you have more sequencers (or even other devices), you can daisy-chain as many as

you want.

Calibration

You can use the trim pot next to each CV OUT jack to calibrate the sequencers to 1 volt per

octave.

Procedure:

Connect a voltmeter to the CV OUT jack of the sequencer you want to calibrate

•

Press RESET to make sure the sequencer is in Ready or Program mode (either will work)

•

Press the OCTAVE UP button a few times to set the keyboard to the highest octave

•

(OCTAVE UP LED on steady)

Press the NOTE C button

•

Adjust the trim pot until the meter reads as close to 4.000V as you can get it

•

Check the C notes on the lower octaves by pressing the OCTAVE DOWN then NOTE C

•

buttons. Each one should be an even voltage. If not, adjust the trim pot until they are as

close as possible