CamJam EduKit 3 Manuale di istruzioni per il montaggio - Pagina 3

Sfoglia online o scarica il pdf Manuale di istruzioni per il montaggio per Attrezzature didattiche CamJam EduKit 3. CamJam EduKit 3 6.

10. Peel and stick battery box Velcro so the box's front is against

the front of the robot box, approximately centered. Peel stick

red breadboard onto battery box so it is against the front of the

robot box, centered. Ensure longest dimension of the

breadboard is against the robot box.

11. Insert the wires from the right motor into the "A" terminals and

the wires from the left motor into the "B" terminals on the

motor controller board. It is not important which motor wire goes into a specific terminal at this

point since the red/ black colors do not guarantee a motor direction. This will be fixed later.

Using a Phillips screw driver, tighten the screws onto the wires. See diagram on next page for

layout.

12. Insert the battery box red wire into the "+" terminal and the black wire into the "-"terminal on

the motor block. (diagram above is from another generation, and it shows "GND" & "VIN",

instead of "-" & "+", respectively). Tighten screws.

13. Connect optical line sensor per diagram. As a note, breadboard is red, not gray and wires will

not be the same colors as shown.