3E THERMOSALD ISC Manuale di avvio rapido - Pagina 16

Sfoglia online o scarica il pdf Manuale di avvio rapido per Controllore 3E THERMOSALD ISC. 3E THERMOSALD ISC 20. Temperature controller for impulse sealing. modular system

3E THERMOSALD ISC Manuale di avvio rapido
4.9 - SETUP PROCEDURES WITH THE AID OF THE CONTROL PANEL
1) Enter the theoretical values (see paragraph 4.8 above)
2) Access the DIAGNOSTIC – ANALYSIS submenu (see paragraph 4.8 above)
3) Read the effective pulsed voltage of the strip, THEORETICAL V.
4) Set the transformer secondary voltage allowing for a multiplication coefficient of 1.5 – 2 for pulsed operation and a
coefficient of 1.5 for continuous operation:
transformer V = strip V x multiplication coefficient (1.5 - 2), select the nearest one.
4.10 - SETUP PROCEDURES WITHOUT USING THE CONTROL PANEL – MANUAL MODE
Calculating total resistance:
R strip=specific resistance[Ohm/m] x strip length[m]
Calculating the strip cross-section S:
Strip cross-section S[mm
Calculating the theoretical pulsed heating currents I:
I heating=strip cross-section S[mm
Calculating the effective pulsed voltage applied to the strip:
V strip=R strip x I heating
Calculating the transformer secondary voltage allowing for a multiplication coefficient of 1.5 – 2 to increase the
sealing speed under pulsed operating conditions and coefficient 1 for continuous operation:
V transformer= V strip x multiplication coefficient (1.5 - 2)
(select the nearest one)
THERMOSALD ISC – MANUAL QUICK START
Manual cod.: 3ES080x_V5.1_QS_EN
Includes all previous models
2
]=strip length[mm] x strip thickness[mm]
2
] x 30[Amp/ mm
2
]
Page Nr.
16
Rev. 2010 / 03
Tot. Nr . 20