Camlogic PFG57 Manuale di uso e manutenzione - Pagina 4

Sfoglia online o scarica il pdf Manuale di uso e manutenzione per Strumenti di misura Camlogic PFG57. Camlogic PFG57 4. Rotary level indicator

In case there is evidence of damage or excessive tearing of the gaskets on the cover or other parts of the device, contact the

manufacturer CAMLogic for the replacement with suitable materials.

The screws on the cover must be fully tightened and the cable glands and/or sealing caps must be properly tightened; make sure

that the power and grounding terminals are correctly connected and in good condition.

REPAIR

The level sensors series PFG05*...L and PFG57*...L can only be repaired by the manufacturer CAMLogic of following

instructions from the manufacturer. In case of doubts concerning malfuctions or repairs, contact the manufacturer: CAMLogic

S.a.s. di Giovanni Guazzetti & C. - Via dell'Industria 12-12/A - 42025 Cavriago (RE) - Italy.

In any case, the repairs must be carried out in compliance with IEC 60079-19 / BS EN IEC 60079-19 standards.

WARRANTY

CAMLogic, in addition to the terms of the supply contract, guarantees its products for a period of twenty-four (24) months from the

date of shipment. This warranty is expressed only in the repair or replacement free of charge of parts that, after careful examination

by the Manufacturer, turn out to be defective.

Warranty, excluding all liability for direct or indirect damage, is considered to be restricted to only defects in materials and has no

effect if the parts returned turn out to have been anyhow dismantled, tampered with or repaired by anyone other than the

Manufacturer.

Warranty likewise excludes damage derifing from negligence, carelessness, bad or improper use of the level gauge, or from bad

handling by the operator and faulty installation. Warranty is moreover forfeit if non-genuine spare parts have been used.

A returned level indicator, even if under warranty, must be shipped carriage free.

Use and maintenance manual for rotary level indicator series PFG05 & PFG57

0601_002_0_rev2 - 10.2022

Page 4 of 4