ESI ES2247B Manuale di istruzioni per l'installazione - Pagina 11
Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Termostato ESI ES2247B. ESI ES2247B 16. 2 channel multi-purpose
programmer
Anche per ESI ES2247B: Istruzioni per l'utente (20 pagine)
Stampa la pagina
Fitting the Back Plate
1. Position the wall-plate (terminals along top edge) with
60mm (min) clearance to its right, 25mm (min) above,
90mm (min) below. Ensure that the supporting surface
will fully cover the back of the programmer.
2. Offer the back plate to the wall in the position where the
programmer is to be mounted, remembering that the
back plate fits to the left side of the programmer. Mark
the fixing positions through the slots in the back plate,
drill and plug wall, then secure back plate in position.
3. All necessary electrical connections should now
be made. Ensure that the wiring to the wall-plate
terminals leads directly away from the terminals and
is completely enclosed within the wall-plate aperture.
Wire ends must be stripped and screwed to the
terminals so that minimal bare wire is showing.
To enter a New Installer Code
1. Move the slider to RUN.
2. Press
enter the landlord settings. A numeric password will be
required to enter these settings.
3. The LCD display will show C0dE. Press the +/– buttons
to enter the first digit of the code. Press the Day button
to move to the next digit. Repeat this until all 4 digits
have been entered and then press the Next
N.B. Only when the code entered matches either the pre-set
or master code can the landlord settings be entered.
The factory default code is 0000.
4. The LCD display will show ProG. Continue to press the
Next
Home, Copy and the + buttons together to
button until the LCD will show NE 0000. Press
button.
11